Controller wiring instructions: wing Yun controller, for example, in order to work at least the motor can be connected to at least four joints, the first controller on the two thick blue and white lines connected to the motor, The red line of the motor, the white line connected to the black line of the motor. Followed by the controller of the two red and black lines connected to the battery, the red line then the battery cathode, black line connected to the negative. The third re-connected to the speed control to the joints, (speed control turn to have three lines, be sure the red line on the red line, black line on the black line phase). Once again connected to the electric lock, open the electric door lock, turn the motor can run.
Voltage: DC 24V
Dimensions: 81 x 65 x 38mm/3.18 x 2.56 x 1.5"
Casing Material: Aluminium
1. black & yellow connector - Brake wire
2. red & black connecotr - Charging port
3. red & black & blue connecotor -Derailleur /throttle
4. red & black connector - Indicator
5. red & blue connector - Power locks
6. red & black connector - Brake light
7. Thick white & blue connector - Motor
8. Thick red & black connector - Battery
If your controller is 7 connectors, then that is less than my 8 connector controller of a power lock connector, I need to install this controller I control the electrical lock on the red and blue two-wire connector can be shorted together.
1 X Brush Motor Controller
Brushed Controller :
Casing material: Aluminium
Motor brushed controller for Electric bicycle & scooter
Rated voltage: dc 48 v
Current limited : 30A
Rated power: 1000 w
Matching motor: dc brushed motor
Under Voltage Protection: 42V
Electric Bike scooter twist throttle accelerator with power display, 5Led battery indicator.
Throttle Works Voltage: DC5V
Speed Adjusting Signal: 0.8V-4.3V
Power display Voltage: DC 42V
Normal: 48V above, 3 Led Green
Half: 47V ~ 42V, Led Yellow
Empty: 42V or less, Led Red
Rotation angle: 0 °~ 70 °
Working temperature: -20 ℃~ +50 ℃
Fits standard 7/8 inches(22.2mm) handle bars
Cable length is approximately 47 inches (1.2m)
Controller Wires Interface Definition:
Battery :Thick Black (Power Negative) /Thick Red (Power Positive)
Motor :Thick Yellow (Motor Negative) /Thick Blue (Motor Positive)
Ignition Switch :Thin Red(VCC)/Thin Blue
Indicator : Thin red (Indicator power output) /thin black (indicator negative)
Brake :thin yellow (Brake signal)/thin black(Negative Power)
Speed governor :Thin blue(Speed handlebar Signal input) /Thin black (Negtive Power) /thin red(5V Positive Power)
Charge Port : Thin red (charge input power Positive) /thin black (Power negative)
Brake Light: Thin red (power Positive) /thin black (Power negative)
Sport: Thin yellow /thin green
1.Please allow 1-3mm error due to manual measurement.Pls make sure you do not mind before you bid.
2.The color may have different as the difference display,pls understand.
1 X 48V Throttle Grip With Normal Grip
1 X 48V 1000W Controller
1 X Black Terminal Ends
1.Air cooler removal tool.
2.Scissor type. four-in-one 3/4", 5/8", 1/2", 3/8", more convenient.
3.Easily separates spring coupling fittings on fuel lines and air conditioning systems.
Model: fuel pipe disassembler (Wrench)
Sizes: 3/8'', 1/2'', 5/8'' and 3/4"
1 X Scissor Type Fuel Line Quick Disconnect Tool
1.Due to different producing batches, product details might be a little different. If you minding the difference, please buy it carefully.
2.Please allow 1-3CM differs due to manual measurement.
3.Due to the different display and different light, the picture may not reflect the actual color of the item. Thanks for your understanding.
100% Brand new and high quality
Made of Aluminium, stainless, durable
4 bright colors optional
Direct fits all cars/trucks, ideal for pursuing the detail of your vehicles
Material: Aluminium Alloy + Rubber O-Ring
Color: Black/Blue/Red/Gold/Full Color (Pls select the color you require.)
Size: As the picture shows
Quantity: 1 Set
4 X Aluminum Fasteners
4 X Nuts
4 X Washers
2 X O-Ring Fasteners
A perfect replacement
High quality material
Ideal replacement for your car, replace the old or broken windshield washer nozzle.
Fit for honda accord 1998-2002
Condition: 100% Brand New
Dimension: like the picture show
Other Part Number: #76810-S84-C02
Placement on Vehicle: front left, right
1 X Windshield Washer Wiper Nozzle
1.Fits most Standard US Manifolds.
2.R134a Air Conditioning A/C Manifold Gauge Set
3.With three-color charging hose
4.Made for Pressures up to 800PSI.
5.High pressure, oil-resistant, durable, wear-resistant, corrosion-resistant.
6.Refrigerant pipe was using full brass joints, corrosion resistance, high sealability.
Working Pressure: 800 PSI
Burst Pressure: 3000 PSI
Material: rubber/ metal
Color: red/ blue/ yellow
Pipe diameter: 11MM
1 X Air Conditioning Manifold
3.Item length: approx. 380mm/14.96"
4.Max. claw width: 80mm/3.15"
5.Item type: welding
6.Body is made of high quality screw after heat treatment, 40ACR forging claw type
7.Black surface treatment, rust prevention, corrosion resistance
8.Strengthen the wide thread design, 1/2DR square hole, can be used with 1/2DR drive tools, or 21mm sleeve and wrench use
9.Maintain spring curvature, permits quick and safe removal or installation of spring while repairing struts
10.Suitable for use where there is limited space under the wheel arches
1 X Pair Coil Spring Compressor
Popular PDR pulling bridge Works on virtually any flat, non-porous surface.
Easily controlled ,removal the dent by yourself with PDR pulling bridge
Made in stronger material with new design, puller tap have different sizes suitable for various sizes of dents
Meticulously inspected and certified for Rockwell Hardness.
Material: Plastic , Acrylonitrile Butadiene Styrene(ABS)
Product Description: PDR Paintless Hail Removal Sticks Auto Body Repair Dent Puller Bridge Glue
1 X Golden Car Dent Lifter Removal
5 X White Glue Sticks
24 X Purple Tabs
1.12 Types plastic rivets for your choice.
2.The biggest feature of the buckle connection is the ease of installation and disassembly,which can be done without tool removal.
3.Material is solid, not easy to wear, easy to use.
335 X Plastic Rivet kit
2.A must for intense hail repair.
3.Simple operation,repair the dent in quickly.
120mm Car Body Paintless Dent Hail Repair Tool
Suction Cup Material
Suction Cup Size
120mm / 4.72"
Adjustable Tape Length
Eye To Eye Diameter
1 X Car Dent Repair Tool
1. 18 Types plastic rivets for your choice.
2. The biggest feature of the buckle connection is the ease of installation and disassembly, which can be done without tool removal .
3. Material is solid, not easy to wear, easy to use.
4. Great for cat,trim bumpers and other door trim.
299 X Plastic Rivet kit
Fit Hole Size
1.Durable squeegee made from high quality stainless steel/rubber/plastic.
2.Scrape off the bubbles & water downright under the film, prevent glass car body and film.
3.Scratch-less, no marring or marks, just smooth motions that easily glides across vinyl films and painted surfaces.
4.Lightweight makes it easy to use and store in smaller spaces.
5.Convenient to use.
Car Tinting & Cleaning Tool Kits for Solar Film
For application of all types of window tint film, paint protection film, decals,solar film,wrap film
1 X Black Rubber Squeegee
1 X The conquerer Tool
1 X Squeegee
1 X Mini Scraper
1 X Block Squeegee
1 X Knife
10 X Spare Blades
Your shopping cart is empty!
The WiFi module ESP-1 is manufactured by using a high-performance chip ESP8285.
This small chip is encapsulated an enhanced Tensilica’s L106 diamond series 32-bit kernel CPU with a SRA..
(Wifi Car Dedicated) NodeMcu Lua ESP8266 ESP-12E + WiFi Motor Drive Expansion Board
This NodeMcu Lua module, is dedicated to the wifi smart car, which means, this module have the special progr..
-50-110 DC12V Cool Heat Temp Temperature Control Switch is available now from our US and UK warehouse
Free shipping to US and UK in 3-6 business days
ship to Canada, Brazil in 7-10 days in US wa..
-This product with wide frequency range, high gain, low noise figure
-This product can be applied to various RF receive front-end and increases communication distance
-Used for Short wave,..
0.28 Inch Digital Voltmeter DC0-100V Adjustable Voltage Tester Meter 3-wire
Operating voltage: 4.0 ~ 40V (with a reverse protection)
Detection voltage: 0.0 ~ 100V
Operating current: ..
Here is the circuit diagram: https://forum.banggood.com/forum-topi c-311466.html
Working current: ..
0.28 Inch Dual Red LED DC 4.5-30V Digital Voltmeter Ammeter 2-200A
Working current: ..
Display Color: Red, Yellow, Blue
The black line connected to the public negative electrode, red line connected to positive pole of power supply, yellow line connected to positive po..
0.36 Inch Digital DC 3.3-30V Voltmeter LED Voltage Meter
Three digit LED 0.36inch
Not directly exposed to ultraviolet
The voltage meter can be used for various voltage testing purposes, wi..
0.36 Inch Digital Voltmeter 0 - 200V Voltage Meter Gauge LED Panel Meter 3 Wire
Update frequency: about 200ms
Measurement range: 0-200V (Optional)
Power range: 4-30V
Measurement accuracy: ..
voltmeter is available now from our UK warehouse
Free shipping to UK in 3-6 business days
ship to Other European countries in 7-10 days
0.36 Inch Digital Voltmeter 3 - 30V Voltage Gauge LED Panel ..
The module is a 12 foot with a clock point four common anode tube (0.36 inch) display module for driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube.
0.4 Inch Waterproof Red Blue LED Light Panel Digital Voltmeter Tester With Reverse Protection
Display mode: 0.4 inch LED
Working current: 0mA-20mA (normal: 5mA-15mA)
Total length: about 150M.
Wire type: 30AWG
Single core wire outer diameter: 0.55mm
Copper core diameter: 0.25mm.
Temperature: 80 degrees, single-strand copper core crossing tin, with antiox..
0.56 Inch 3-30V 5-120V LED Panel Voltage Meter 3 Digital Display Voltmeter
DC Voltmeter: 3-30V, 5-120V
Power supply: DC3-30V, 5-120V
Measuring range: DC3-30V, 5-120V