1. On-board DIP switch, you can easily adjust the drive segments
2. Terminal power connector for easy connection drive power
3. Compatible with 12 / 24V drive scheme
4. Suitable for 42 step..
Fully assembled & tested, no soldering required
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost
The modular design includes plug in ste..
1. This module can be used in both Chitu motherboard, and other open 3D Printer motherboards.
2. This high power module helps your 3D printer equipped with the Chitu controller board (ca..
1. 9V-40V DC power supply
2. H-bridge bipolar constant phase flow driver
3. The maximum output current is 4.0A (eight optional)
4. Up to 32 segments of six kinds of sub-modes available
-Small density, good elasticity, good toughness;
- Good plating.Smoothness is very good;
- High purity, all materials are not doping waste
- Good effect, print the part model and the corner..
- CNC Shield Board
Size(L*W*H): 68 x 53 x 18 mm
Voltage: DC 12~36 V (At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when ..
-Adjusting the laser power
-Low Light Function
-Support for High Power Laser
-Become the DIY engraving machine first choice,support for adjusting the laser power, weak ..