3D Printer Module Board

Show:
Sort By:

210A High Current Upgrade RAMPS 1.4 Heated Bed Power Module For 3D Printer

Features: 1. Power module for controlling 3D printer heated bed 2. Handle high current but without being heat at the same time 3. Powerful MOSFET HA210NO6 4. Allow PID control of the heated be..

5.90€

Geekcreit® 3D Printer A4988 Reprap Stepping Stepper Step Motor Driver Module

Description: A4988 is a complete microstepping motor driver with built-in translator for easy operation. This product is available in full, half, 1/4, 1/8 and 1/16 step modes operate bipolar step..

1.56€

Geekcreit® 3D Printer RAMPS 1.4 Controller + MEGA2560 R3 + A4988 With Heat Sink Kit

We will default sending carton package to replace the plastic box, but there may some stocks are still packaging with plastic box, please note about this before you buy it.Features:RAMPS 1.4 The ..

17.12€

Geekcreit® 3D Printer Stepstick DRV8825 Stepper Driver Reprap 4 Layer PCB

Description: The module has an interface pinout is almost the same with A4988 stepper motor drive carrier, so that it can be used as a higher performance in a pull-down menu the plates replaced i..

1.75€

MEGA 2560 R3 With USB Cable + RAMPS 1.4 RepRa + A4988 Drivers 3D Printer Kit For Arduino

Features:-The RAMPS 1.4 board is designed to fit the entire electronics needed for a RepRap in one small package for low cost. -RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platfo..

19.41€

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm CableFeatures:It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating lay..

1.12€